|
| |
Micro-Rip™ 2000 Fence
The Micro-Rip™ 2000 fence has an indexing pin on each end of the fence which engage the links on the precision sprocket chain at the front and the back of the saw.
The sprocket chains are connected by a common drive shaft so that the links are always aligned and when the fence is set on the table the index pins engage the links and align the fence parallel to the blade.
The knob on the drive shaft can be rotated to move the fence the length of the saw table or a few thousands of an inch, no more tapping for final position or alignment.
General Information
Saw with 10" aprons
| apron each side | 18 " left, 20" right |
| aprons on right side | 8" left, 30" right |
| aprons on left side | 28" left, 10" right |
Saws with 12" aprons
| apron each side | 18" left, 20" right |
| aprons on right side | 8" left, 30" right |
| aprons on left side | 28" left, 10" right |
The Micro-Rip™ 2000 will fit most saws with table depth (front to back) of 17" & 27" by just bolting to the existing mounting holes on table. Some may require drilling of new mounting holes (Maximum of 4 holes, the cast iron table is easy to drill if needed).
For Table Saws with 27" front to back table depth
4 Bolts will mount to existing holes in most of these saws: Sears, Delta, Grizzly, Jet, Powermatic
For Bench Top Saws with 17" front to back depth
4 Bolts will mount to the existing holes in these saws: Makita, Skill, Grizzly, Ace, Delta, Tradesman, Master Mechanic, Central Machinery
|
|
