|
| |
Micro-Rip™ 2000 Saw Fence Install
 |
STEP 1: Install front rail of the MICRO-RIP™ saw fence (MICRO-RIP™ adjustment
knob can be on either the left or right side of saw) |
 |
STEP 2: Install rear rail of the MICRO-RIP™ saw fence |
 |
STEP 3: Install drive shaft and couplings |
 |
STEP 4: After leveling front and rear rails to the saw table,
install the fence and square to the saw BLADE (not the table) |
* NOTE: AS NEEDED:
- Relocate START/STOP Switch
- Place the measuring scale on the front rail
- Make adjustments during the initial set-up to assure proper allignment.
|
|
